Configuration of the lighting requirements of the installation

As of the 2018.g version, CYPELUX allows users to establish limit values for the lighting parameters that are calculated by the application. This way, the program can verify the requirements of the main codes. The levels that can be configured by users are:

• General requirements of the project
  • Total maximum power (W/m2)
• Specific requirements of each zone
  • Normal lighting
    • Installation
      • Minimum chromatic performance (Ra)
      • Maximum total power (W/m2)
    • At work plane level
      • Minimum maintained average horizontal illuminance (Em) (lux)
      • Minimum average uniformity (U0)
      • Maximum uniform glare rating (UGR)
      • Daylight factor
      • Maximum VEEI (W/m2)
      • Maximum DPI/100lux (W/(m2*100*lux))
    • At floor level
      • Minimum illuminance (Emin) (lux)
      • Minimum average uniformity (U0)
  • Emergency lighting
    • Installation
      • Minimum chromatic performance (Ra)
      • Minimum height of the lights (m)
    • At floor level
      • Minimum maintained average horizontal illuminance (Em) (lux)
      • Minimum average uniformity (U0)
    • In the equipment
      • Minimum maintained horizontal illuminance (lux)
    • In evacuation routes
      • Central axis
        • Minimum horizontal illuminance maintained in the road (lux)
        • Uniformity (min/max)
      • Centre band
        • Minimum horizontal illuminance maintained in the band of the road (lux)

Since this configuration does not depend on the geometry or specific properties of a project, it may be saved to be used in future projects.