Grupo de contenido: Tiene grupo de contenido
In version 2025.d, the import of the nodes defined in the structural model has been implemented. This task can be carried out in the import of structures from CYPE 3D, ETABS® or SAP 2000®. A node will be created with the same reference as the node in the structural model and with the same bars. […]
The "Filter" tool has been added to the light selection panel. Thanks to this new feature, the available lights can now be filtered according to the following parameters: This improvement streamlines the light selection process, allowing specialists to quickly find products that meet the technical specifications of the project.
As of version 2025.d, a small diagram with the layout of the bolts for each operation will be included in the section on the definition of the bolts in the summary report.
The index drawing of each bolt, anchor or timber fastener has been implemented in the 3D view of the connection. The options to show or hide these indices are enabled under "View options".
In version 2025.d, a tool has been implemented to define the loads applied to each bar based on the mechanical properties of its section. In the load edition panel, on the force table for each bar, the wizard for modifying the forces of the selected load case appears. This tool changes the table value of […]
Up until version 2025.d, any modification to the operations resulted in the loss of the results of the finite element model, even when these changes didn't affect the analytical model. However, as of version 2025.d, the results will be retained as long as the modifications do not alter the analytical model, with only the necessary […]
As of version 2025.d, connection reports can include images of the connections. In the "Model" and "Analysis" tabs, the "Images" section has been added to the toolbar ribbon. This section offers a tool for snapping images, as well as a library for managing them. By clicking on "Snap image", a snap of the 3D view […]
In the connection analysis model, one of the bars is set as the load-bearing element, unless a baseplate has been defined. The remaining bars are connected to this element, on which the loads are applied. Up until version 2025.d, the bars connected to the load-bearing element had no external links, allowing users to define forces […]
As of version 2025.d, CYPEHVAC includes a new module that can analyse and design controlled mechanical ventilation (CMV) systems. The program includes all the elements required for this type of installation: ducts, heat recovery units, plenums, supply valves and exhaust valves, silencers, etc. from different manufacturers. To use these features and others included in CYPEHVAC, […]
In version 2025.d, the CYPECAD, CYPE 3D and Foundation Elements programs incorporate the lateral stability analysis module to facilitate the design of deep foundations subjected to significant lateral forces. This module complements the structural check of reinforced concrete piles (if your licence includes the "Piles II: Structural check" module), by allowing the checking of pile […]
In version 2025.d, the CYPECAD, CYPE 3D and Foundation elements programs incorporate structural checking of reinforced concrete piles for deep foundations. The new module "Piles II: Structural check" complements the design of this type of foundation, verifying the safety of piles as a structural element of reinforced concrete according to the criteria of the selected […]
Version 2025.d includes two new modules for checking and analysing piles (Piles II and Piles III) in CYPECAD, CYPE 3D and Foundation elements. In the previous version 2025.c, the Piles I module was already implemented in the same programs. Therefore, as of version 2025.d, users of CYPECAD, CYPE 3D and Foundation elements have three pile […]
