With the 2014.d version, important improvements have been introduced in the analysis and edition of the radiant floors which provide more adjusted results and greater control on behalf of users.
In this sense, the automatic selection of the most unfavourable circuit of each manifold has been optimised, which is what will establish the impulse temperature calculation. Now, the automatic selection of the radiant floor carried out by the program, not only takes into account the load required by each circuit (as was done in previous versions), but also takes into account the specific properties of each circuit.
Furthermore, in the 2014.d version the possibility has been implemented for users to determine, in accordance with their criteria, which is the most unfavourable circuit, that will establish the calculation of the impulse temperatures. This way, users can have greater control on the design of the installation. The selection of the most unfavourable circuit is carried out when the circuit is edited.
In both cases (automatic selection and manual selection) the program indicates, in the analysis report, which circuit has been used to calculate the impulse temperature of the manifold; the value of its thermal fluid density is displayed in bold text in the circuit design section.
