Data input and output sequence for designing and analysing sewerage networks

The design and analysis of a sewerage network can be carried out in the program using the following sequence of data input and output:

1. Creating a new project (from "File", "New").
2. (Optional) Linking to BIMserver.center and importing topographical data from the BIM model.
3. Configuring general installation data (in the wizard for creating a new project or via "General data", "Edit general project data"), including the definition of materials and land.
4. Defining assumptions and combinations (under "General data", "Edit loadcases"; and under "General data", "Edit combinations").
5. (Optional) Importing DXF-DWG/DWF templates or images (from "Edit templates").
6. Adding nodes (from "Nodes", "New").
7. Adding segments between nodes (from "Segments", "New").
8. (Optional) Reviewing and/or adjusting dimensions in the longitudinal sections (from "Longitudinal", "Modify elevations in the longitudinal section").
9. Analysing and/or designing the installation (under "Analysis", "Analyse/Design").
10. Reviewing the compliance status of the checks performed (via the "Next combination/Select combination/Previous combination" options) and the analysis results (via "Nodes", "Information"; and via "Spans", "Information").
11. Printing reports and job drawings (from "File", "Reports/Drawings").
12. (Optional) Exporting to BIMserver.center (via "BIMserver.center", "Share").