Sequence of data input and output for drawing the multi-line diagram of an electrical installation

The multi-line diagram of an electrical installation can be defined in the program using the following sequence of data input and output:

1. Creating a new project (from "File", "New").
2. (Optional) Linking to BIMserver.center and importing BIM model data.
3. Drawing options settings (under "Settings", "Drawing options").
4. Inserting and/or reviewing the diagrams that make up the multi-line diagram using the options available in the left-hand side panel. These may have been generated from information extracted from the BIM model. A diagram layout will be established based on the panels, sub-panels and special elements of the installation entered into the original programme.
5. Inserting and/or reviewing the elements and the routing of the connection lines that make up the installation (from the options in the "Buses", "Earth", "Power supply", "Switchgear", "Terminal elements" and "Measure and control" blocks) on each drawing in the workspace. These may have been generated from information read from the BIM model.
6. Printing drawings (from "File", "Drawings").
7. Exporting to BIMserver.center (from "BIMserver.center", "Share").