Share

Module code

NLT

Associated programs
Modules required for installation:

Bars only in tension

The non-linear analysis of bars that work only in tension is part of the CYPE 3D module "Bars only in tension". In order to be able to use this module, the program license must include the permission to use it and also the permission to use the "OpenSees analysis engine".

Non-linear combinations

In non-linear analyses, a superposition of loadcases cannot be carried out, so a model analysis must be carried out for each load combination to be studied. Therefore, the load combinations are defined on the basis of the loadcases defined in the job data and the types of combinations to be used for checking the elements of the structure are specified for each of them.

The program allows users to define the combinations to be analysed in three ways:

  1. By manually entering each combination.
  2. By automatically generating all possible combinations from the situations defined in the project.
  3. By analysing the results obtained from a linear analysis.

Analysis

The program shall offer an option to perform non-linear analyses when non-linear combinations have been defined or elements with non-linear behaviour have been entered into the model.

In the linear analysis, the behaviour of the non-linear elements shall be considered linear. It is possible to perform a non-linear analysis without having previously defined the combinations. In this case, the program will determine the combinations to be analysed from the results of the linear analysis.

The checking of the bars is carried out with the results available after the analysis. If both linear and non-linear results are available, the program combines the results of both types of analysis according to the types of combination that apply to each element.

Viewing the results

As well as being able to view the results by loadcases and by combinations, the results can also be checked by non-linear combinations. In the case of the combination check, if a combination has been analysed as non-linear, it will be indicated with the suffix "NL". The results of the linear analysis for that combination can also be checked by ticking the "Linear combinations only" option.

Defining bars only in tension

To consider a bar that works only in tension, a generic type bar is entered, and in the new "Behaviour" option, the  "Only tension" value is selected.

For shells with subgrade modulus, users can choose between "Linear" or "Only compression" behaviour.

Reports

The program allows users to generate force reports by non-linear combinations for nodes, bars and shells.