Share
Associated programs

Assigning design options in the design of a water evacuation system

In the "Installation" tab of the "Water Systems" tab, in the "General options" of the "Project" group of the main toolbar, there is an option for assigning the design options of the water evacuation system in the project:

Design options

Selects one of the sets of design options previously defined in "Design options" under "General checks" in the "General options" and assigns them globally to the desired element types.

In the window that appears when clicking on this option, a set of design options is selected and the parameters defined therein are reported for the following categories of elements:

  • Horizontal pipes
  • Vertical pipes

Then, the "Selection" option is used to access a table showing the currently defined parameters. Here, users tick the box to the left of each element type where they wish to assign the selected set of design options. The program will modify the design parameters of these types after accepting this window.

Note:
The option sets defined in "Design options" under "General checks" of the "General options" and assigned via the "Design options" of the "Project" group can only be used to change the values of the parameters that are previously activated for each type of element defined in the “Design and check options to be carried out” section of the “General options”.